Using the # HR26 with a weight distribution kit isn't recommended because the extender will lower the hitch tongue weight capacity by one third, so I wouldn't advise using an extender. A weight distribution system exerts huge amounts of leverage to raise the front and lower the front of the tow vehicle. An extender would provide a weak link in the chain that could lead to an unsafe situation.
You didn't mention how much additional length you need or the specific drop you needed, but the... view full answer...
The only 15K rated hub assembly that we currently offer without the drum would be Dexter part # DX42KR. This hub has an 8 on 275mm wheel bolt pattern and uses the following bearings, races, and seals:
Inner Bearing Cup # 3920
Inner Bearing Cone # 3984
Outer Bearing Cup # 28622
Outer Bearing Cone # 28682
Oil Seal: # 10-56
Hub Cap: K71-148-00
Prior to purchase I recommend checking to make sure the bearings and seals will match your current setup, as well as the wheel bolt pattern so... view full answer...
We sure do!
I'd recommend part # AKBRKR-MC which provides 10 magnet retaining clips that are compatible with Dexter 10 and 12 inch brake assemblies. view full answer...
The Ultra Faucets RV Shower Valve w/ Vacuum Breaker, # 277-000024, allows for the option but does not have a specific matched shower head. There are multiple choices available, this is designed with a 13/16' fitting.
One option is the Phoenix Faucets Airfusion RV Handheld Shower Set w/ Flow Controller, # PF276047 which does come with a shower head holder. view full answer...
Yes, the TireMinder A1AS TPMS for RVs and Trailers # TM69FR is just what you need. This TPMS will monitor your RV's tire pressure and temperature and use Bluetooth to wirelessly send updates to the LCD monitor or through your smartphone or tablet via the app. The system includes a repeater to boost the signal between the sensors and screen.
I've attached a video below that will offer some additional information and walk you through the installation process. view full answer...
We have two different camera systems that would replace the 3rd brake lamp assembly on the rear of your cab that would indeed utilize the factory display in the dash. The correct system for you will depend on if you have the 8 inch or the 4.2 inch monitor (measured diagonally). If you have the 8 inch monitor, use # 3460001 or # 3460002 if you have the 4.2 inch monitor.
This being said, this part will only work if your truck has the rear-view camera at the rear of the truck. If it does... view full answer...
According to the Q-206 document that was released by Ford the correct brake controller harness needed for a 2013 Ford F53 chassis would be the # 3035-P if you were installing a Tekonsha brake controller like the P2 # 90885. view full answer...
Go To Results